Differences

This shows you the differences between two versions of the page.

--- in-place_versus_separate_prints_for_moving_joints [2024/02/01 17:27] – jasonh
+++ in-place_versus_separate_prints_for_moving_joints [2024/02/01 18:44] (current) – jasonh
@@ Line 15: / Line 15: @@
 No other adjustments were needed to the model.
+{{ :simplejointinplace.jpg?400|}} To print **in-place** required a bit more work on the model.
+To stop the parts fusing together during printing touching walls needs to be separated. I found that a distance of 0.3mm worked.
+This gap was also needed for the holes, meaning they now had a diameter of 5.6mm.
+After printing and the satisfying "snap" when moving the joint, the joint itself is looser than the printed-separately one. It's easy to see why, that 0.3mm gap around the shafts isn't tight enough.
+{{:img_4231.jpeg?400 |}}Comparing the two joints, the printed in separate pieces is on the left and the print in place on the right. You can see the shafts are a much tighter fit on the printed separately. So for a small articulated figure, it's looking like avoiding in-place printing is the best option if you want stiff joints.
+//Printed on a Bambu Lab P1S, 0.4mm nozzle, Smooth High Temp plate, 0.16mm Optimal quality.//